The issue of e-cigarette types

Category problems are basically divided into the following categories


Step by step, the simplest and most special are the first two fires of disposable smoke. Is an integrated structure, generally have a charging port, but according to the actual capacity in fact, there are no charging port products. The structure inside is very simple battery structure, heating atomization structure and oil storage structure (I have dismantled one with sponge oil storage), this is used up and thrown away, the whole is disposable products.


The most common version of an e-cigarette, also known as a cigarette, consists of two parts: a stick and a bomb. The smoke rod generally has a display. As a power source, the smoke bomb is mainly smoke oil and heating core. The manufacturer has pre-filled the smoke oil in it, which is sealed and the proportion of each part has been allocated to the most appropriate disposable supplies. Of course, after all, smoke bombs are very expensive, so many people punch holes, fill oil and plug in empty smoke bombs to reuse, but too many times heating core loss will produce harmful substances. Official and unofficial blanks are available under many brands, and there are even products that can separate the oil tank from the heating core.


In response to this demand, the product, which consists of a blank cartridge with a good opening and a matching smoke rod, greatly reduces the cost. But the match between the oil and the core must rely on their own experience to explore, if not, the original 4 or 5 times of the core will be directly paste scrapped.


Then there is the big smoke equipment (here is the beginning of my play in the hand but I do not have and do not need the equipment/relevant knowledge can go to B station to look for), this kind of start there are a lot of people are players, the amount of smoke and battery capacity will be large, you can play oral suction, light lung suction, and so on.


The structure is mainly composed of atomizer and base (battery rod) two parts. It is generally divided into finished atomizer (the heating core with fixed capacity resistance caliber, the whole discarding and replacing loss) and DIY atomizer (the inside structure should be made by oneself/there are oil storage type and drip type/I think my classmates make thieves complicated and play to this layer is very expensive). The base is used to adjust the voltage. When the resistance of the atomizer is fixed, the voltage determines the amount of smoke, which is the so-called big smoke. There is also a special device that combines diy atomizer with other parts into a small square box, which is powered by batteries and the voltage decreases with use. This device is one that I have not studied, but after debugging, it is said that it can even achieve the effect of all the above devices.


In addition to the various vaping devices, another category of e-cigarettes is the so-called heating non-combustion devices. Generally, it is not as cool and sweet as the equipment of atomization principle, and the taste and taste are closer to the traditional cigarette. The same may also produce a small amount of harmful substances produced by the traditional cigarette, but it is much better than the cigarette.